ALL PRICES BELOW ARE ESTIMATES ONLY!! PRICES ARE SUBJECT TO CHANGE UPON INSPECTION!!
Arm, Control:Tubular $25.00/SteelStamping $30.00
Fuel Cell Can $60.00
Housing,Third Member $100.00
Manifold Intake 8 Cylinder $80.00
Bar, Ladders ($/pair) $90.00
Mod. Car Bumper $35.00
Bell Housing $35.00
Oil Pan $50.00$25.00
Blower Drive Snout $30.00
Pulley 2 & 3 belt (5" diam) $20.00
Blower Housing $150.00
Pulley 4" $15.00
Body Mounts $20.00
Shaft Steering Column $45.00
Brake Caliper $45.00
Spindle, Front $35.00
Covers Spring Coil $30.00
Spring Leaf $40.00
Valve - 4 cylinder $30.00 Sprint Car
Valve - 6 cylinder $45.00 Dash $25.00
Valve - 8 cylinder $45.00 Front Axel $35.00
Cylinder Block V8 $350.00 Motor Plate $20.00
Cylinder Black V6 $250.00 Nose Wing $50.00
Cylinder Heads V6 or V8 $125.00 Seat $65.00
Cylinder Heads Straight 6 $300.00 Side Panels $25.00
Drum, Brake (Auto) $50.00 Top Wing $150.00
Engine Plate $20.00 Triangular Sides $17.00
Fan Rear End (no gears or grease) $150.00
1 Piece $30.00 Fuel Cell cage $40.00
2 Piece $40.00 Rub Rails $20.00
**Prices for frames are for new frames. **Used frames are an additional $100. **Frames include 1 set of bumpers & rub rails.
Sub GM $250.00 Dragster $475.00
Dragster (Door Car) $650.00 Dragster (1/2 scale) $225.00
Funny Care $650.00 Kart $150.00
Late Model $600.00 Super Stock $600.00
Legend or Dwarf Car $450.00 Midget $275.00
Micro Sprint $250.00 Modified $600.00
Type your paragraph here.
Keep in mind, All prices include abrasive blasting, thread masking, or other preparations as needed.
Parts are to be free from any plastic, rubber, bearings, excessive dirt, oil, and grease.
Prices are for single stage coating using in stock colors.
Special order colors will incur an additional charge to cover cost and shipping.
Cast parts such as aluminum as well as clad items such as chrome plated parts may experience “out gassing” which is bubbles in the powder coating caused by gasses escaping the part during curing in the oven.
We will take every precaution to avoid this but we cannot be held responsible for any bubbling caused by porous castings or clad items.
Clear coat is REQUIRED over most chromes, metallic, silvers, and certain other colors.
Clear coating of any part adds 50% to the price. Multi-stage coatings add 50% per stage.
We will warranty against cracking, flaking, or peeling for 1 year on new parts and 6 months on all used parts.
If your item is not listed in our price lists please let us know what you have and we will work with you to get the job done.
***Prices are minimums and subject to change without notice***
Each piece must be disassembled or additional charges will apply.
If you do not see a part listed that you would like to have powder coated, contact us.
All prices below are estimates only. Prices are subject to change upon inspection.
Strut bar ends $15.00 each
Sway bar $60.00-$80.00
Timing Cover $30.00-$40.00
Transmission Pan $35.00-$45.00
Turbo Compressor Housing- Inlet $45.00
*Turbo Turbine Housing- Outlet in Ceramic See Ceramic Coating Section
Washer $1.00 each
Water Pump $40.00 (must remove bearing inside)
Wheelie Bars $80.00-$120.00
Windshield Wiper Arms $30.00 pair
Click the image below to go to Prismatic Powders Website to choose your colors
Click the image below to go to Columbia Coatings Website to choose your colors
*Heat Shield-Ceramic See Ceramic Coating Section
Hood Hinges $20.00-$40.00 each
Hood Latch-Bottom $15.00-$25.00
Hood Latch-Top $15.00-$25.00
Hub Cap (metal) $25.00 each
Intake Manifold 4 – 6 – 8 Cylinder $80.00-$120.00
Intercooler $60.00-$120.00 (depending on size)
Intercooler Piping $1.00 per inch
License Plate Frame $20.00
Lug Nuts $2.00 each
*O2 housing in Ceramic See Ceramic Coating Section
Oil Pan $55.00-$75.00
Pulley Under 4” diameter $20.00
Over 4” diameter $25.00
Radiator Support $125.00-$175.00
Rear Housing Full Size $150.00-$200.00
Springs $30.00-$40.00 each
Strut bar upper $20.00 (only middle section if ends come off)
Strut bar upper $40.00 (ends included as 1 full bar)